Website logo
Curtain Making Continuous

Step 1. Cut fabric to width: For continues sheers/voiles we normally use 2.5:1 fullness self pleating triple pleat tape and for continues solid fabric we normally use 2.0:1fullness self-pleating triple pleat tape.

We use the following formula to determine the width of fabric to start with before sewing anything:

Track width x tape fullness plus 40cm.

Example for a 2 metre window for sheers (2.5:1 tape):

200cm x 2.5 = 500cm + 40cm = 540cm.

If there will be 2 curtains: Each one will be cut at 270cm.

Example for a 2 metre window for solid fabric (2.0:1 tape):

200cm x 2.0 = 400cm + 40cm = 440cm.

If there will be 2 curtains:

Each one will be cut at 220cm.

Step 2. Make side and bottom hems, put weights in each corner. Iron fabric before starting if required.

Mark the wall

Note: We normally use a double 10cm on bottom hem and a single 3cm on side hems. If making white sheers better to cover weight in white fabric.

Step 3: Iron hems and fabric:

Fix small gold brakcets to wall and mark centre

Step 4: Calculate what the finished drop should be:

If the curtain is hanging down to the floor:

Measure the distance from under the track to the floor and deduct 3cm. This will make the curtains hang about 1.5 cm above the floor.

If the curtain is hanging in mid air:

Measure the distance from under the track to the point you want the curtains to finish and deduct 1.5cm.

Step 5: Add 50mm to the finished drop calculated in the previous step and make final fabric cut. The 50mm is to allow for folding the fabric over behind tape.


Before attaching track to wall

Before attaching track to wall

Step 6: Fold fabric over 50mm and iron in of pin crease to follow if needed.

Fix track to wall

Step 7: Sew the tape onto the back side of the fabric with the visible pockets facing upwards and Easy Track writing the right way up.

Knot the strings on one end of the tape first.

Fix track to wall

The tape is sewn to the top edge of the fabric. On top of the folded back fabric 50mm flap:

Fix track to wall

Sew tape on 1st stitch as close to top as possible, then the 2nd as close to the bottom as possible:

Fix track to wall

Step 8: Pull strings to pleat fabric: Pleats are obtained by gathering the fabric together on the drawcords:

Fix track to wall

One side of the curtain is attached to a fixture, e.g. door handle. The curtain tape is held with two fingers next to the group pleat and slid along.

This process is repeated and previously made group pleats are continuously fed along the length of the tape until the curtain is completely pleated.

Make sure the space between the group pleats stays smooth.

Knot the drawcords tightly together behind the last pleat and bundle them or wind them around a cord-tidy.

Step 9: Attach the gliders to the curtain: The gliders are like a lockable safety pin. They are fed through the top pocket at each side of the group pleat and hold the pleat into place further.

Fix track to wall

Step 10: Hang curtains up on track: Steam or iron if required.